Propellant Characterization and Motor Simulation

Background


Gathering Data
Test Stand / Alan's work
ARTS

Simulating


Burnsim
Alan's work
MM, RR, ER, et all

Hardware

The main requirement are identical propellant runs cross a wide range of Kn's.

For Alan's testing sessions the requirements are four 38mm reload sets of Qty two of 2" long grains with 1/2" cores. He provides the motor and nozzles. The collected propellants are run occasionally and preferably you help. You get back the thrust and pressure curves and your a an n numbers as well as a curve fit.

For Mike's method the ARTS gathers all data but pressure - so a two grain 38mm motor isn't strictly required - just four identical flights with only the Kn being different..

I plan on leveraging both for each propellant. Grains to Alan and Arts flight.

I'm planning on making the data gathering flights generally at our Bayboro, NC field. It's a huge field - but almost always very windy. So I'll also use 2 grain 38mm motors (2x2x0.5 grains same as for Alan) for consistency and also fairly quick turnaround to get in 4 flights for the day.

I haven't "filthied-up" my lathe yet so I'm ordering nozzles from Loki, metal from onlinemetals.com, thrust and nozzle rings and hardware from McMaster


38mm
54mm
76mm
98mm
114mm
152
Motor Casing
Tubing, 1.5" OD x 0.083
Pipe 2" Sch 80 6061
.095" wall
Tubing 3" OD
x .115" wall

x .188" wall
Pipe?
x .237" wall
Pipe?
Forward Closure






Thrust Ring
Spiral 1 1/2" Shaft 91650A510
0.050 Groove 0.056 +0.004 -0
-case-
Spiral 3" Shaft 91665A630
.093 Groove .103 +0.005 -0



Nozzle washer
Loki
Loki
Loki



Internal snap rings
Snap 1 5/16 Bore 98409A232
0.050 Groove 0.056 +0.004 -0
Snap 1 7/8 Bore 98409A244
0.062 Groove 0.068 +.004 -0
Snap 2 3/4" Bore 99142A640
.093 Groove .103 +0.005 -0



o-ring
215 or 216
223
230
232 nozzle
236 closure
232
240
429
Internal Groove Tool
Discount Tools
INT-20-1510
Discount Tools
INT-20-1570
Discount Tools
INT-20-1620



Eye  Bolt
1/4-20
5/16-18
3/8-16




Smoke Closures

Ed Romani / Brand X / TruCore

76-38mm liner
54-Bt50 paperliner
38-AT RDK- compressed in w/ buna tube
 
Can be for garolite tube also.  Garolite tube doesnt have close tolerances. Can range as much as 0.010".
And can differ from manufacturer.
76- 1-5/16 max
54- 1" max
38- 5/8" max